Cisco SFP-10G-SR= SFP-10G-SR Network Media Converter

Product Information

The dual power supplies can supply up to 800-W power across the input voltage range. The load is shared when both power supply The Cisco GLC-BX40-D-I, GLC-BX40-DA-I, and GLC-BX40-U-I SFPs operate on a single strand of standard SMF. The Cisco SFP-10G-LR module is capable of working with a link length of 10 km on any basic single-mode fiber. It is completely in compliance with the 10G Base-LR standard and uses 1310nm lasers. The LR module has no minimum distance, which is why it is ideal for short connections carried over a single mode fiber.

You can use the second SSD slot to upgrade to the MSP. The MSP must be installed in the second slot. The second SSD slot remains empty unless you install the MSP in the second slot. The MSP Behind an enterprise internet edge firewall in an inline in a transparent bump-in-the-wire configuration or as a standalone Network interface virtualization: Each PCIe interface created on the VIC is associated with an interface on the Cisco UCS fabric interconnect, providing complete network separation for each virtual cable between a PCIe device on the VIC and the interface on the fabric interconnect. See Install, Remove, and Replace the Network Module for the procedure for removing and replacing network modules. provides network connectivity when there are software or hardware failures. Hardware bypass is useful on ports where the FirepowerYou cannot swap SSDs between different Firepower platforms. For example, you cannot use a 4100 series SSD in a 2100 series The Cisco SFP-10G-LR-X is a multirate 10GBASE-LR, 10GBASE-LW, and OTU2/OTU2e module for extended operating temperature range. It supports a link length of 10 kilometers on standard Single-Mode Fiber (SMF, G.652). stores threat detection results for use in future analysis. It supports the Advanced Malware Protection (AMP) software feature. The Cisco 10GBASE-SR module supports a link length of 26 meters on standard Fiber Distributed Data Interface (FDDI)-grade Multimode Fiber (MMF). Using 2000 MHz *km MMF (OM3), up to 300-meter link lengths are possible. Using 4700 MHz *km MMF (OM4), up to 400 meter link lengths are possible. SFP-10G-SR-S does not support FCoE.

bypass on this inline interface set. You can only enable hardware bypass on an inline interface set if all the pairs in the A GLC-BX40-D-I or GLC-BX40-DA-I device connects to a GLC-BX40-U-I device with a single strand of standard SMF with an operating transmission range up to 40 km.The Cisco 10GBASE Dense Wavelength-Division Multiplexing SFP+ Module offer the following features and benefits: On the Firepower 2130 and 2140, the OK LEDs on the rear power supplies flash after the switch is turned off; this is expected You can fit four copper SFPs in either the top row of ports or the bottom row of ports. Both rows cannot be populated at the The 1000BASE-BX-D and 1000BASE-BX-U SFPs, compatible with the IEEE 802.3ah 1000BASE-BX10-D and 1000BASE-BX10-U standards, operate on a single strand of standard SMF. Cisco has introduced that the S-class modules are suggested to be used in enterprise network. In addition, the operating temperature range is smaller, thus, S-class module is recommended for shorter transmission distance applications compared with other standard modules.