Teltonika 4G-RUT240 Compact Industrial 4G LTE Router

Product Information

Fixed provider information and IMSI value representation when SIM and modem cannot provide this information Inactivity polling can be disabled to disconnect stations based on inactivity timeout so that idle stations are more likely to be disconnected even if they are still in range of the AP. Network protocols:TCP, UDP, IPv4, IPv6, ICMP, NTP, DNS, HTTP, HTTPS, FTP, SMTP, SSLv3, TLS 1.3, ARP, PPP, PPPoE, DHCP, Telnet

Fixed settings migration issue that caused unreachable Internet after upgrade from a legacy FW version While the device is designed to accept input voltage of up to 30 VDC peaks, high voltage power supplies can harm the device. If you want to use high voltage power supplies it is recommended to also use additional safety equipment to suppress voltage peaks from the power supply. Do not expose your device or its accessories to open flames, lit tobacco products, liquid, moisture, or high humidity.

Note: Firmware version RUT2_R_00.07.01 released on 2021.11.18 was removed due to an issue with IPsec tunnel while using mobile connection.

When RUT240 is configured as mesh gateway it provides internet access to other mesh nodes. When configured as mesh node it acts as a mesh router which forwards traffic to and from mesh gateway. Nodes also connect other wireless devices to the network such as laptops and cellphones. Extended Service Set Identifier is a name used to identify access point to which client will connect. Hawnhekk, TELTONIKA NETWORKS tiddikjara li dan l-RUT240 huwa konformi mar-rekwiżiti essenzjali u dispożizzjonijiet rilevanti oħra tad Direttiva 2014/53/EU Niniejszym TELTONIKA NETWORKS deklaruje że RUT240 jest zgodny z zasadniczymi wymaganiami i innymi właściwymi postanowieniami Dyrektywy 2014/53/EU

More firewall zone settings can be configured from the Network → Firewall → General Settings → Zones section. The Teltonika RUT240 compact LTE 4G router will be available from June or July 2017 and will replace the RUT500 3G Router. The RUT240 provides an embedded 4G Modem with single SIM card slot, with easy SIM access via SIM tray on the side of the router. It will work with all UK mobile phone networks for 4G and 3G mobile broadband Internet connectivity and uses a standard size SIM card. Of course, this 4G routerwill work with 3G or 4G Fixed IP SIM cards which is the preferred method of providing remote access to the router and connected devices.

The General Setup section is used to turn a wireless device on or off, select the operating frequency (WiFi mode and channel), transmit power and define a country code. The SSIDs section is used to configure your wireless access points (AP) and wireless clients (STA).Este equipo o dispositivo debe aceptar cualquier interferencia, incluyendo la que pueda causar su operación no deseada. The Update Firmware section is used to upgrade the device's firmware. Firmware can be upgraded either from server or from an image uploaded from your computer. Specifies whether interface settings (IP, route, gateway) are assigned to the interface regardless of the link being active or only after the link has become active. On the other hand, if the uploaded a firmware file that is incompatible with your device, you will see an indication such as this: When an interface is set to act as a DHCP Relay, it redirects all received DHCP request messages to another specified DHCP server:

This device meets the official requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by authorized agencies. The device must be used with a minimum separation of 20 cm from a person’s body to ensure compliance with RF exposure guidelines. Failure to observe these instructions could result in your RF exposure exceeding the applicable limits. The Relay Configuration section is used to relay and dynamically redirect incoming connections to a target host. Its main purpose is extending the wireless network. For example, when the device is in Wireless Station (client) mode, it can be used to bridge WAN and LAN interfaces to create a larger wireless network.Fixed vulnerabilities CVE-2022-3524, CVE-2022-3566, CVE-2022-3567, CVE-2022-39188, CVE-2022-45934, CVE-2022-47929 Expanded the data that is sent to the Cumulocity cloud with device log, mobile data usage nd GPS data The Certificate Generation tab provides the possibility to generate TLS certificates required for secure authentication and communication encryption used by some of the devices services.